Lot of 7 vertical autoclaves hl 15 (remaining from lot of 10)

PRE-SEASON LOTS RESERVATIONS UNTIL STOCKS LAST

AISI 304 stainless steel
Exchange pocket system with patented spiral design resting on legs complete with insulation

DIMENSIONS:
Outside diameter: ~ 1050 mm (D) + (200 mm insulation) = 1250 mm outside
Cylindrical part height: ~ 1500 mm (HF)
Legs H: ~ 700 mm (HG)

MATERIALS:
Plating: AISI 304 stainless steel
Bottom: Domed AISI 304 stainless steel
Roof: convex AISI 304 stainless steel

SURFACE FINISH
Tank interior: 2B planking (polished from rolling mill) Top and bottom satin finish
External tank: Coating 2B insulation (polished from rolling mill)
These finishes are guaranteed with adhesive plastic film protection before the start of any processing.

WELDINGS
The welds are performed with automatic and manual T.I.G. with inert gas protection (Argon)
on both sides of the joint, at full penetration, pickled and washed Grinding and fine brushing of natural heels
internal and external. Flattening of the plating welds by cold rolling.

STRUCTURE
Structure suitable to withstand the nominal capacity with a density of 1.1 kg / dm3 + second overpressure
6 BAR approval according to 97/23 / EC P.E.D. Design and certification in accordance with EN standards
ISO 13445.

COMPONENTS
- N ° 4 pyramidal support feet obtained from bent sheet metal equipped with adjustable feet with thread and plate
Ø120 for floor support.
- Lifting eyebolts applied to the roof.
- Elliptical hatch in AISI 304 certified P.E.D., placed on the lower part of the plating with internal opening /
external
- DN50 total drain with stainless steel ball valve, DIN50 connection.
- DN50 partial drain with stainless steel ball valve, DIN50 connection.
- Predisposition for connection for DN50 agitator with stainless steel ball valve, DIN50 connection, inclined
towards the bottom of the tank (DN50 extractable agitator excluded)
- DN50 internal reassembly pipe with stainless steel ball valve, DIN50 connection
- DIN DN50 fitting complete with blind swivel on the center of the roof
- Tap takes samples with ball valve.
- Level unit with needle valve in stainless steel, polycarbonate tube ø 16, steel protection, return
superior.
- Analog thermometer.
- Well for temperature probe.
- N ° 1 Heat exchange pockets applied to the shell made in a cavity by spot welding with protection of argon gas complete with inlet / outlet connections for the carrier fluid.
- KZE system with pressure gauge and PED 6 bar approved pressure safety valve
- Total insulation in double layer polyurethane panels with staggered joints sp. total 100 mm, bottoms
injected sp. 100 mm, riveted finish in flowered AISI304.
- Insulated counter door in AISI304
- CE marking and type certificate according to European Directive 97/23 / EC